ClubCJ - The CJ Lancer Club

hello everyone, just got my lancer..hope to learn some tips here to improve my ride... sorry for the poor quality..







also wanna ask if 18x8.75 +30 will fit lancer without pulling the fenders? I'm on tein coils and plan to roll all fenders.. using 225/40 with a bit of camber(hopefully not).. will there be rubbing issue for full load?

Welcome to CCJ!

Car's looking sweet as mate, but it's a bit hard to mod it and maintain it since you're in Singapore eh?

Welcome

welcome, not sure if they will fit,could always see if u can get a test wheel and see how easily it fits

Oh with the fenders.

You'll need to roll, definitely. Not so sure about pulling, you're probably going to need to as well.

Welcome to the forum fellow neighbour

broyther wrote:also wanna ask if 18x8.75 +30 will fit lancer without pulling the fenders? Im on tein coils and plan to roll all fenders.. using 225/40 with a bit of camber(hopefully not).. will there be rubbing issue for full load?

Hello! You should be able to fit those rims with a roll + maybe a slight pull. In regards to camber though, @ your lowered height, you're probably running somewhere around -1.5 to -2 natural camber already anyway. I doubt you'll need additional camber to make it fit.

hey thanks for the warm replies! not that strict to modify my ride here as long as I stick to the rules..


was tempted to buy a 2nd hand 18x8.75 +30 XXR 527 rims to fit without pulling the fenders.. I have seen some lancer in this forum with same rims but +35 and only roll fenders.. so whether that +5 offset makes a lot of difference..

roll all fenders and run -2 degree camber all round and should be ok

car stands out

been a while since I last updated my ride... do forgive for blur pictures...
just change my rims..

now she sit like this..

looks nice

Hey man, that is one beautiful set up! .. always been a fan of te37's.
what size are those?

welcome