ClubCJ - The CJ Lancer Club

Hi whats every one using?? looking for some fresh pads looking for some that is good for every day use that does very little squealing and of course very little dust any ideas and cost!!! Thanks Gazza

Hi mate,

We'd recommend QFM HPX, which are a Bendix Ultimate equivalent, but low dust and rotor wear. Fronts are $110, rears are $119, and plenty in stock. Shipping is free when you order front and rear pads together, or else $8 per axle set individually.

We do have a stack of other options in stock, but for high performance street use with low dust the HPX would be my pick.

Regards,
Greg

i suggest getting ferodo ds2500 thats the ones i got and lee! its really good with minimal brake dust i would say.

you can get it for about 270 usd delivered via map performance.

Yup, DS2500's are a good thing.

John from V-sport up in Sydney was selling fronts for $259.

I run the model up from what Greg @ GSL suggested.

They are called the QFM A1RM. Bit dusty and can get a little squeaky, but I have never had them fail on either my lancer or the focus.

H,i so with my DBA Premium 2 piece Brake Rotors Front and rear would both the above options be OK should i get reasonable wear out of them Thanks gazza

DS2500 will be fine, and I run the A1RMs on DBA4000s, and they work well. DBAs are a fairly hard disc so tend to last better than RDA etc. I did run the A1RMs on RDA disks on the lancer and they worked well also....

these are the stock evo x MR front rotors

ken, those are rotors of an MR or gsr PP

ok thanks sanjeet i will keep that in mind not ready to fit them yet.

red hats ken do it

megatron wrote:red hats ken do it

HHmmmm i am warming to the idea might be to much red with the red brembo's

maybe anodized black hats with red anodized nutz